Ferrari F-355 Kit Car Build

Vehicle: 1988 Pontiac Fiero Forumala
Body Kit: Ferrari F-355

Initial Fiberglass Mock-Up
After removing the factory body panels the fiberglass shell could be laid onto the car . From initial mock-up, we knew we would have to do some cutting for proper clearance of the hood and B-Pillar/Roof section.

Side / Rear Shot

Rear Shot

Another Front Angle Shot
 
   
   
The front bumper has been cut away in order for the hood to close better. The radiator was slid down to provide more clearance for the hood and will be re-mounted approximately 3" lower than stock later. The open area in the front will need to have a new bumper fabricated with mounting tabs to secure the front of the kit to the car.